Power Checker
🔍 Power Checker
A debug / inspection tool for the electrification system. Right-click a target block to print its electrification state to chat.
How to use
Hold the Power Checker and right-click any of:
| Target | Information shown |
|---|---|
| Wire Insulator | Number of attached wires / how many are energized / per-wire ON/OFF |
| Substation Cubicle (core or dummy) | Buffer FE / capacity / connected insulator & wire counts |
| FE Inverter (placed) | Buffer FE / capacity |
| FE Inverter (on a train) | Train total storedEnergy / total inverter capacity |
| Pantograph (placed or on train) | Currently contacted wire segment / FE picked up this tick |
| Anything else | "Not applicable" — passes through |
Sample output
[Insulator @ (123, 65, -42)]
Attached wires: 3
Energized: 2 / 3
▸ wire 1: ON (to insulator @ (118, 65, -42))
▸ wire 2: ON (to insulator @ (128, 65, -42))
▸ wire 3: OFF (to insulator @ (123, 65, -50)) ← cut grid[Substation @ (110, 64, -40)]
Buffer: 425,032 / 1,000,000 FE (42.5%)
Energized insulators: 6
Energized wires: 14[FE Inverter (Train #train_jb_03)]
Train storedEnergy: 12,400 / 80,000 FE (15.5%)
Mounted inverters: 4 (20,000 FE capacity each)Troubleshooting
| Symptom | Check |
|---|---|
| "Train won't move" | Tap pantograph — if pickup is 0, the wire above is not energized |
| "Wire looks dim" | Tap an insulator at the end → walk the grid back to the hub |
| "Substation isn't filling" | Tap the cubicle — confirm buffer level and input rate |
| "Train drains too fast" | Tap an inverter — compare consumption vs pickup |
Related
- Substation Cubicle — primary FE source
- Wire Insulator — energization junction
- Pantograph — current collector
- FE Inverter — onboard FE buffer